HOW DO I CHANGE A TEMPERATURE UNIT IN MY PCR191W The temperature measurement unit (C or F) can be changed only through entering clock setting procedure: 1.HOW CAN THIS BE FIXED Please consider the following when atomic time is not set during the initial setup.Place batteries in the outdoor transmitter first, then into the atomic clock.After 10 minutes both the Indoor and Outdoor areas on your clock should have a temperature showing.
![]() To do this: The time zone (LCD2) will start flashing (Default setting -5h). Select the desired time zone by pressing and releasing the key. Equity 31269 Atomic Projection Clock Manual Time SettingPress and release the SET key to enter the mode Manual Time Setting. MANUAL TIME SETTING In case the atomic clock is not able to detect the WWVB-signal (disturbances, transmitting distance, etc.), the time can be manually set. What does malwarebytes mac check forPress and release the SET key to switch to the Month Setting. Press and release the SET key to move to the mode Date Setting. ALARM SETTING To enter into the alarm setting mode: Hold the ALM key for 4 seconds. If the temperature data is not received 10 minutes after setting up (the display shows - - -), then please check the following points: The distance of the atomic clock or outdoor temperature transmitter should be at least 6 feet away from any interfering sources such as computer monitors or TV sets. Collins, Colorado and transmits the exact time signal continuously throughout the United States at 60 kHz. The signal can be received up to 2,000 miles away through the internal antenna in the atomic clock. However, due to the nature of the Earths Ionosphere, reception is very limited during daylight hours. Will work as normal quartz Successful reception of WWVB time signal (tower clock. Will search for the WWVB time WWVB time signal blinking) signal overnight. POSITIONING Before permanently mounting ensure that the atomic clock is able to receive WWVB signals from the desired location. MOUNTING WITH ADHESIVE TAPE With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Spectraview 2 serial numbersSee setting 2) Move the atomic clock closer to the transmitter or place the transmitter closer to the atomic clock. Make sure the clock is at a receivable range from the transmitter. ![]()
0 Comments
Leave a Reply. |
AuthorBrandon ArchivesCategories |